difference in behavior with opointment between autocad 2013 and 2014

[Lululu]

Hello everyone, my name is lucia,

I hope you can help me!

in practice I noticed a change in the otting between autocad 2013 and 2014.

I uploaded a video to youtube to show you but said in a few words:
in autocad 2013 and earlier if I draw a line (e.g. horizontal), I exit from the command, return in the command line and port the cursor on the fine osnap (right example) of the line previously drawn, I suggest direction and towards with the mouse (e.g. horizontal and right) and then insert a measure (e.g. 90) followed by sending, my line will begin at a distance of 90 units and will be to the first drawn line.

in autocad 2014... no!

here the video (set 720 hd as definition):
[video=youtube;-uoJlzxn9f0]http://www.youtube.com/watch?v=-uojlzxn9f0[/video]Can you explain why? !

Thank you very much! ! !

♪

 

[MassiVonWeizen]

below options > drawing board> check the magnet check.

personal opinion. . way of drawing barbaric and easily prone to errors

 

[Lululu]

Thank you very much for the answer :redface:
I checked and unfortunately it's marked.
Well if used carefully it is very fast. from the barbarian is exaggerated :biggrin:

the fact is that all 2014 autocads just installed behave like this (other than 2013 or earlier)

mystery really. if you have ideas are welcome! !