different tabella

[jim78b]

how do I in a separate automatic table to put in a single cell the 3 sizes say of a sheet? Like 300x100x30?

I'm going to the property. ..click on the height of the length, and then......

 

[michele81]

Simply like this: enter the custom property that will be shown in the table, click the quota from 300, then write "x", click the quota from 1000 and so on. of course the quotas must have been prepared appropriately or added later! In this way, changes to the quotas you have linked to the table are automatically updated. I hope I've been useful to you!
greetings
Michael

 

[jim78b]

:smile:thank you for your availability...I have another problem....in one set I have to add a component that I have to rotate, but do I use the mating command? I find it very difficult

 

[jim78b]

I'm sorry back! I'm doing the table with it distinct materials and not with excel, I click on the odds as you told me but if then I want to change the size of a component? How do I act?

 

[re_solidworks]

:smile:thank you for your availability...I have another problem....in one set I have to add a component that I have to rotate, but do I use the mating command? I find it very difficult

if the correct couplings can be rotated. If for example you have a concentric couple and a coincidence to block the piece axially, the comonent can rotate.

I'm sorry back! I'm doing the table with it distinct materials and not with excel, I click on the odds as you told me but if then I want to change the size of a component? How do I act?

you cannot change them from the table, if you want to insert them can only be for display.