sergiorustici
Guest
Hello everyone
perhaps this is not the forum most suitable for my problem,(but I don't find suitable forums )
I come to the point. I have a digitizer -neolt type mx 2000-
I should like to make it clear to you that the Commission has not been able to do so.
autocad for changes in dxf with current operating systems (win7-win8 ).
I would be very grateful if you could help me on the net.
I know you should use autocad serial cables and wintab drivers and I don't know anything else, if you can give me a tip please.
always someone came across something like that.
Thank you all for your attention.
Sergio
perhaps this is not the forum most suitable for my problem,(but I don't find suitable forums )
I come to the point. I have a digitizer -neolt type mx 2000-
I should like to make it clear to you that the Commission has not been able to do so.
autocad for changes in dxf with current operating systems (win7-win8 ).I would be very grateful if you could help me on the net.
I know you should use autocad serial cables and wintab drivers and I don't know anything else, if you can give me a tip please.
always someone came across something like that.
Thank you all for your attention.
Sergio