Joel
Guest
Good evening;
I put here my question as to the draft draft for catiav5, but in reality it concerns the quotation in general.
I wanted to know how to indicate, drawing, a quota for dimensional control. i.e. if on a dimensional or geometrical quota it is enough to insert an indicative symbol so that the tester can carry out verification (a design verification).
Of course I have identified the odds that must be verified by the tester, but I would like to understand if there is a rule that I can refer to.
I found a rule around, i.e. ISO 14405, but I can't understand how to apply it (i.e. I can't find examples around).
Thank you
Joel
I put here my question as to the draft draft for catiav5, but in reality it concerns the quotation in general.
I wanted to know how to indicate, drawing, a quota for dimensional control. i.e. if on a dimensional or geometrical quota it is enough to insert an indicative symbol so that the tester can carry out verification (a design verification).
Of course I have identified the odds that must be verified by the tester, but I would like to understand if there is a rule that I can refer to.
I found a rule around, i.e. ISO 14405, but I can't understand how to apply it (i.e. I can't find examples around).
Thank you
Joel