disconnect lines in sections

[carmine improta]

I seek help to understand how to disconnect lines to clean a section in archicad 12. Thank you.

 

[DarthVader]

there are various tools, collect, extend, consolidate retini (and one doing the same things for the lines) etc.

 

[carmine improta]

I would first like to thank the student friend of Calabria who kindly answered me. I do not know if I have not understood the answer or I have not explained well in the question, that I repeat:
using archicad 12, I can't transform the elements (three-dimensional) that make up the section in two-dimensional and therefore in lines and retinals. with version 8, there was a command that disconnected the elements that made up the section. Therefore some lines could be eliminated that were part of the drawing in section, without altering the state of the plant.
I hope I've been clearer this time. thanks for the collaboration.

 

[carmine improta]

using archicad 12, I can't transform the elements (three-dimensional) that make up the section in two-dimensional and therefore in lines and retinals. with version 8, there was a command that disconnected the elements that made up the section. Therefore some lines could be eliminated that were part of the drawing in section, without altering the state of the plant.
I hope I've been clearer this time. thanks for the collaboration.

 

[DarthVader]

select everything, copy, close the section and paste into the project "sheet". all elements become at that point lines and retini