display thread in inventor

[Zaraki]

Good day to all!
I will explain to you my problem: use inventor 2015 and I would like to physically display a thread in both the axieme and idw.
Now as now in the axieme the thread is practically drawn only on the surface, so if I make a 1/4 view the thread is as if it was not at all present in the piece, while in the idw I can only visualize the double parallel line.
Thank you all in advance for your answers.:smile:

 

[ninfh]

If you need to have ridges, flanks, backgrounds, etc. of a thread physically in the model, the only solution is, in fact, to make it in the model.

make a tooth sketch and use it as a profile for a helid

 

[Catafratto]

If you want to try this... (I didn't.) I think there are also YouTube videos on how to use it
https://apps.exchange.autodesk.com/....autodesk.com:threadmodeler_windows32and64:en

 

[rf.infissi@libero.it]

I installed it and used it, and I have to say it works discreetly
clearly weighs the part considerably.

 

[rf.infissi@libero.it]

other particular if you have to do it on a thread of a hole the hole must necessarily be done with the hole command and not with extrusion of the circles otherwise it does not work

 

[ninfh]

I didn't know it existed as an application, does it also make the waste?