display various arrangement on the same sheet in nx9

[mtvonno]

hi, in nx9 I often use arrangement. for example I have a part with two arrangement "a" (default) and "b". select the display of a.
I go to the drawing and create two views of one of the arrangement a and one of the b. all right here.
if I now go into the model and visualize the b, in the drawing is updated the view to with the model b and this I would not. How can I solve this? I'm wrong.

 

[Dottor_Scott]

Hello, I'm begging you that I'm not the best expert on
Arangment, so I don't want to take you off the road.
However the next day I used this function and had no problems,
I tell you how I did

then I made a set with a 40ine of components, the need was to have
two representations on the table, a 'normal' and one with an open bracket to allow
the parade of a component.

That's how I did it.
- I created the axieme normally by inserting components and related constraints
- I made a 'b' arrangement in the window of the creation of these I
selected property and I put 'ignora constraints'
- I made the arrangment b 'current' (not default)
- I moved the bracket to the second position (open speaker)
- I made a table with two views, one with a and one with b
If I go back to the model and change the current layout, I don't change my views.

I don't know if I helped you.

 

[ceschi1959]

a work around for 'this stuff is to make three arrangements.
the starting one uses it by default.
at first glance in the 11 there is no this problem because if you manage the arrangements in the part it shows you the views only if you load them from there.
Hi.