deep70
Guest
Hello everyone, I am with the following problem:
I have been commissioned of the frames to put on the table and so far nothing strange except for the fact that all the frames were made in multibody and not in the "saved" environment therefore all the tubulars were modeled through extrusion (heresy) and not with the usual method in the appropriate environment. Now if the customer is okay so is good to me, but when the time comes to insert the distinct where I take it? question from a million or maybe more... would any of you know how to tell me if there is a method to have a separate cut or in this case parts?
Thank you all in advance for any given answers.
Good day to all.
I have been commissioned of the frames to put on the table and so far nothing strange except for the fact that all the frames were made in multibody and not in the "saved" environment therefore all the tubulars were modeled through extrusion (heresy) and not with the usual method in the appropriate environment. Now if the customer is okay so is good to me, but when the time comes to insert the distinct where I take it? question from a million or maybe more... would any of you know how to tell me if there is a method to have a separate cut or in this case parts?
Thank you all in advance for any given answers.
Good day to all.