disunure one polyline

[MARCOC]

Hello everyone
in autocad it is possible to bring back a closed polylinea I open to the original state, so with all the lines and separate arches, as if it exploded? ? ?
I don't remember if there's a command and what it is.

Thank you very much

 

[MassiVonWeizen]

command esplodi

 

[MassiVonWeizen]

@marcoc ????

 

[MassiVonWeizen]

@marcoc hai risolto

 

[Zac69]

@marcoc hai risolto

no new, good new.. .

 

[MassiVonWeizen]

no new, good new.. .

this is obvious, otherwise he would not have let pass even half an hour, as he does in his other requests
But thank you wouldn't suck and you should have.

By the way, assuming that my new is a good new answer if it was given in the same question.

 

[Zac69]

It was a joke. I know how present you are and I like your answers and your constant urges to get a match.

 

[MassiVonWeizen]

It was a joke. I know how present you are and I like your answers and your constant urges to get a match.

I knew it, but I'm also an incurable trash.