gnogno80
Guest
I need a great help is 2 weeks I put in all the ways but I can't get the results for this simulation, it's a piece supported to 80 forces of pressure along its length and a centrifugal force of 250 turns per minute, they advised me to use a mesh based on curvature with elemneti with a maximum size of 3mm, although my laptop is not there, so I had to agree with the wrong size and ? I tried to perform the analysis using the adactive-h method to intensify mesh in areas with greater stress but ninete. ..unfortunately I can not attach the xke piece with mesh and loads occupies 70mb...the piece and a shovel obtained from a pvc tube...in this discussion you find the image of the piecehttp://www.cad3d.it/forum1/showthread.php?t=13960&highlight=gnogno80