does not run the round unload between folded corners!

[Hybrid]

Good morning. I can't let the program perform automatic unloading round at the intersection of the edges of a folded sheet. as you can see from the photos, even setting up with custom parameters is not followed!
so to prepare it for the laser I have to hand them all....

 

[ninfh]

to change it directly on the bending processes instead of the default sheet values take the change?

 

[Hybrid]

to change it directly on the bending processes instead of the default sheet values take the change?

Do you mean by using the "angle-junction" command? already tried. basically inevntor does not conceive of round sheet metal discharges lower than the thick of the sheet.... those that makes me are however "out of center from the crossroads of the fold lines.

 

[ninfh]

I meant double click on flangia4/5/6 and change it from them instead of by default sheet values, just to see if the jobs are following the right default rules or not

 

[bich]

sometimes I do not take it because the edge has been executed with two different functions like "flangia" and "flangia contour", other times because the discharge imposed is too small compared to the thickness of the sheet.