draw a cone trunk

[PaoloR1]

Bye to all,
a client asked me to draw him a cone trunk, and until there was no problem, but I asked myself this:
if the design with the sheet/track function, inventor makes me the development of flat sheet?

if someone has experience about it, they are well accepted the advice.

Thank you and hello.
Palo

 

[ninfh]

short answer: Yes.


If after you've done it as a hopper, you don't realize the flat model is because you forgot to use the drilling command and cut the sheet.

 

[eugenesis]

the cone trunk (with separation..) has always developed even when the function "tramoggia" was not there .
Now it can also be scented with respect to the base, while before you could not develop it with that form.