drilling table in sight flat repetition

[pierluigip]

hello to all

I am doing a sheet metal part to make quotes to various firms

I'm not very experienced in this matter and probably the question I'm going to ask for knowledge that goes beyond solidworks

I'll give the dxf to the supplier,
Is it right to put the drilling table on the view of the flat repetition (very comfortable because it's only one ) ?

or do I have to make so many drilling tables how many are the views where the holes are?

attach the pdf file
thanks good work

 

[Ivan1990]

hello to all

I am doing a sheet metal part to make quotes to various firms

I'm not very experienced in this matter and probably the question I'm going to ask for knowledge that goes beyond solidworks

I'll give the dxf to the supplier,
Is it right to put the drilling table on the view of the flat repetition (very comfortable because it's only one ) ?

or do I have to make so many drilling tables how many are the views where the holes are?

attach the pdf file
thanks good work

depends if you want them to make them before the folds, that's fine, if you have to do them after you have to quote them in each view, however, unless you cut lasers, the position odds of the holes are lacking.

 

[Mike1967]

hello to all

I am doing a sheet metal part to make quotes to various firms

I'm not very experienced in this matter and probably the question I'm going to ask for knowledge that goes beyond solidworks

I'll give the dxf to the supplier,
Is it right to put the drilling table on the view of the flat repetition (very comfortable because it's only one ) ?

or do I have to make so many drilling tables how many are the views where the holes are?

attach the pdf file
thanks good work

before you worry about the table, you have to make sure your development is
compatible with supplier fold equipment.
a theoretical development is not said to be exact to an end.
When some customers give me their dxf, I verify my parameters after which I contact them and ask for adjustments of the k factor so that the folded piece (we fold them) with our molds, result in tolerance.
if, instead, fold them you are sufficent the dxf file and a pdf file with quotas so that the supplier can verify if the geometry is scale 1:1

for the quote, already only with the dxf file and a drawing with at least the bulk quotas, your supplier will be able to calculate cutting time and material cost.
for the details mentioned above, they will contact you, in case.

 

[pierluigip]

depends if you want them to make them before the folds, that's fine, if you have to do them after you have to quote them in each view, however, unless you cut lasers, the position odds of the holes are lacking.

before you worry about the table, you have to make sure your development is
compatible with supplier fold equipment.
a theoretical development is not said to be exact to an end.
When some customers give me their dxf, I verify my parameters after which I contact them and ask for adjustments of the k factor so that the folded piece (we fold them) with our molds, result in tolerance.
if, instead, fold them you are sufficent the dxf file and a pdf file with quotas so that the supplier can verify if the geometry is scale 1:1

for the quote, already only with the dxf file and a drawing with at least the bulk quotas, your supplier will be able to calculate cutting time and material cost.
for the details mentioned above, they will contact you, in case.

Thank you very much for the answers.