drilling with 2 different diameters 2 overlapping sheets

[nikkke]

hello to all
I have 2 rectangular plates superimposed of random thicknesses.
I wanted to ask if it is possible with the wizard creation of the holes (or otherwise but in only one function) to make 1 through hole that generates 2 different diameters in the 2 sheets:
on a hole of 8,5mm and on the other hole of 10mm

Thank you

 

[MassiVonWeizen]

make a laminated hole, the one for tcei screws

 

[nikkke]

make a laminated hole, the one for tcei screws

Okay, thanks, so do what I need. .
and if you want to add a third sheet with a diameter still different you can always do with the same function?

 

[MassiVonWeizen]

Yes. If you look at the function of the guided hole there are two sketches.
one is the positioning point, the other is the sketch for cutting in revolution.
enter the second and change it to your liking; Two important things must be kept in mind:
1 the modifications that add that change the geometry of the original hole have nothing to do with the holes wizard function so if you come into change of the function (not the sketch) it could be that you give error... you just have to try to understand
2 the entities and quotas of the original hole should not be deleted in any case otherwise in case of change function (not sketch) the error is certainly 110%; On the other hand, the pilot quotas and the building entities can be transformed.
wanting you can also transform all the original sketch from construction and make a cut in revolution completely different

As a result of the modification of the sketch it should always be checked that entering and leaving the function there are no problems of reconstruction in order not to run the risk of continuing with the modeling and then to find a mistake in the function that sends in cow hours of work.

 

[nikkke]

perfect, then I connect with an equation the depth quotas to the various thicknesses of the plates. .

 

[MassiVonWeizen]

do update courses opens eyes on existing things, but never used
to do what is required by nikke instead of using the barbaric system to change the sketches of the advanced holes since 2017 you can use the advanced hole to create any type of hole with a unique functionhttp://help.solidworks.com/2017/italian/whatsnew/c_advanced_holes.htm