dynamic analysis

[mazzu]

proe wildfire2

Hello everyone!
I am facing a dynamic analysis of a set with the "dynamic" package of proe wildfire2.
someone can tell me how to calculate a f2 force in a generic point of the articulated system having f1 (see attachment "schema.doc").
I tried with "force balance" analysis by applying a load cell at the point of f2, but this type of analysis makes a calculation of f2 in one system configuration. Would you tell me how I can graphics the result of f2 on the whole system run?


Thank you in advance!

 

[PTC]

Hi.

If you want to get a graph of the resulting force for each step of the movement you have to create eq analysis of forces.

once performed the analysis add a load cell measurement with the measures tool and ask to plot it in relation to the each time step turn analysis.

I hope I've been helpful to you... if you tiserve the calculation send me the model and tell me the version of creo or proe that it is.

Hi.

 

[maxopus]

Also this ptc was firm for over 3 months.

 

[PTC]

I apologize maxopus for the answers to the threads a little "old" if they are to be considered such.

I think, perhaps mistakenly, that if at a thread there are no answers or if these are generic an approach is not wrong with the intent to improve the forum perhaps with 3d models and concrete solutions since they are scarce.

wikipedia owes its success to this, it is very dynamic, and that's why it turns out to be the first indexed on all search engines.

as they say... a caval donated... .

Anyway, I'll be more careful, and I'll be right there.

Sorry about the fugitive interference.

Hi.

 

[maxopus]

you don't have to apologize, your contribution is still appreciated.
Welcome to cad3d.