editing table on draftsw

[francesco1990]

Good evening,
I apologize in advance if maybe the discussion I'm opening had already been raised, but the key words I used did not show me discussions about my specific need.
I have performed a joint gusci joint in 3d environment and of this I have to deliver the table with intermediate section of the component.
This includes screws at the section plan, so I had to specify to the program not to dissect the whole bolt in order to maintain the right construction of the head and the nut.
However, the threads of the screw must be marked in the table and the problem arises here. I have tried to add them from the annotations section, but what the program proposes does not follow the norms. also other details (thickness of some lines etc. ) I'm not what they should be.
I therefore ask myself: "How can I directly change these views on solid works? "
I remember that on solid edge there was the possibility to do this, but I did not find an equivalent on sw.
If a way to solve my problem is not there, how do I import everything on autocad without losing the scale of the views?

thanks in advance
france

 

[MassiVonWeizen]

the thread you can put it in the bolt in the environment part. insert > annotation > cosmetic thread; selections the edge and in the drop-down menu of the annotation should be the norms.
to facilitate you in the sections with bolts in the parts that include this category (dades, bolts, thorns....) you can insert in the properties of the component the variable "isfaster"and give it value 1 (Call on how to do)
in this way when you do the sections you will tell them not to dissect the fixes and they will be excluded automatically.
as to the lines you can manage them through the options of the tools document > options; But you should understand what doesn't come back.

 

[francesco1990]

I press that because of the short time for delivery I imported everything on autocad and modified from there. However it is better to deepen for the future.
I used the screws present in the toolbox and in the part I highlighted the cosmetic thread.When though then I ran the section in the draft, the bolts I had to exclude them from the section to be able to maintain the constructions. therefore no representative line of the hazelnut diameter of the screw is drawn. I tried to add them through the annotation command that contains a reference to the threads, but the representation it gives does not conform to the norm. for this I asked if it was possible to go to change the draft always in sw environment as well as you can do on solid edge