elimination double elements in sketches

[strudeldemele]

Good morning to all,
I often happen, when amounting a dxf, to find a casino of overlapping elements in the sketch that weigh the file.
Do you know if with "repair sketch" it removes me? or is there another command to do so?

Thank you very much for the courteous attention.
good day and good work at all

 

[MassiVonWeizen]

Just try. . .
However, you have to do a cleaning job on the dwg before importing

 

[strudeldemele]

ok thanks, in fact it is the only solution found.... but reading the guide spoke of a deletion during the repair sketch... even if it doesn't seem to me, I was hoping for an unseen option

hello and thanks again