emulsified

[Nicolò040297]

Good afternoon to all,
I would be interested in creating a template file (to understand how standards exist in inventor x sheets and parts) for profiles.
the purpose would be to avoid the passage of creation of a set and insert the profiles from the center contained, and to create the profile directly but obviously also using here in the center contained.
I hope I explained.
Thank you.

 

[Peppe]

First, you're in a wrong section and not in inventor's.
second, the fact of having different parts/lamiere templates is due to the fact that the 2 things enable different modeling commands.
third, I don't know what you want to do.

 

[Nicolò040297]

that arrogance,
In the meantime, you can answer the good afternoon.
In addition if you have not understood the question explain to me how you can deduct paragraph 1 and 2.
However, I was asking for access to the creation of a profile through the contained center without having to pass through the creation of a set.

 

[Peppe]

point one, if you do not write in the right section of the forum the post will have little visibility from inventor users.
point 2 is you talking about hardened (sheet parts)
point 3 if you explained better pima you avoided losing time both.
Good day

 

[DrBarde]

if the idea is to have an ipt file that is created as a derivative of the contained center, that I know, at least until 2020 that I use now, does not exist. needs the starting aid where to insert it.

 

[Nicolò040297]

Grazzie dr. Barde.

 

[Peppe]

However, I was asking for access to the creation of a profile through the contained center without having to pass through the creation of a set.

 

[Focus]

discussion moved