error in constraints: geometry is not published

[fidippide]

Good morning to all, I have problems in assembling two simple components. I can't use any bond anymore. the resulting error is visible in the attached figure. I recently changed the cat settings as suggested by the forum (no hybrid modeling and settings as indicated in a guide posted in the past). How could I get away? Thank you!

 

[falonef]

Hi.
in the catpart you must publish the references (plans, surfaces, lines etc.) that you will then want to use in the catproduct to bind the components.

other possibility: go to tools > option > assembly design ... and disable the option that force the use of only public elements.

 

[fidippide]

Hi.
in the catpart you must publish the references (plans, surfaces, lines etc.) that you will then want to use in the catproduct to bind the components.

other possibility: go to tools > option > assembly design ... and disable the option that force the use of only public elements.

thanks for the falonef answer. I tried to go in tools> public elements... but it does not publish anything ("the xxx element cannot be published"). I never had this problma when I used hybrid modeling.
I have enabled in the menu you suggested the function "use any geometry" in the tab "wins". Now go!
Thank you!