error put in the table

[springhio]

boys good morning
I opened a .prt file with pro/e 4 but when I put it on the table doing new> drawing I get the following error:
the name of the view saved front does not exist in the model
How can I solve this?
Thank you.

 

[springhio]

and also how can I put on the table the imported features or see quotas?

 

[maxopus]

Hi springhio, I'm sorry to say you started with the wrong foot.

you did not read the rules, otherwise you would have submitted to other users.
you have opened two discussions in practice for the same topic and this, always according to the regulation, is not allowed.

for the moment I'll give you the other discussion.

You should also indicate which version of pro/e you are using.

As for your problem, you are probably using a design mask with preset views.
If you create a new component from imported files and do not use a start part for its creation, you will not have the preset views that require the design mask.
then as first you have to create the new file having a start available and having set the option in the config.pro for creating new parts with a certain start part.

 

[springhio]

I'm sorry, so what's the option in config.pro for the start part?

 

[springhio]

the version is the wildfire 4