estension cm1 e pbd

[Half65]

First of all I apologize if it is not the right section but perhaps please address me thank you. It's the first time I've been approaching two cutters with numerical control. a me stores the files *.cm1 and is a mazak vtc-30c and the other me stores them as *.pbd and is a mazak nexus 510c-ii.
my question was; can I bring files cm1 into the most recent mazak that has pbd files?

 

[ale47p]

but are they master/gcode files? Since they're both mazak, is there no phone/mail address?

 

[Half65]

I'll do this, but maybe for those who do it, he'd already give me a couple of straights on the dafarsi: )