estrusione

[genale]

Hey... I haven't been taking rhinoceros for a while.
I wanted to know how to extinguish or extend a solid on a sloped surface and not perpyndocular to the face to be extended. I don't know if I was clear:
Thank you.

 

[Il marangon]

take the extrusion command
select the suprfice
confirm the selection
at this point in the pront of the commands there is the heading direction or direction, if you click with the mause on the word you can unleash the direction of extrusion.

do some evidence and possibly ask for clarification.

Hi.

 

[genale]

I just want to say to the face of the solid stretch to the surface of the other floor.. That's all.

 

[mariuss.r]

I just want to say to the face of the solid stretch to the surface of the other floor.. That's all.

You already asked a very similar question... The procedure is the same as I told you in this response post
http://www.cad3d.it/forum1/showthread.php?t=13800#8


mario