Cristallo
Guest
proceeding to an etransimt of a design, during the saving of the zip file, the autocad dialogue presents as default a folder in which to save the zipped file.
that I remember, autocad took this "default path" from where the design resided, so doing the etransmit, always going ok,ok, saved the zip file in the same folder where the dwg resides.
for some time instead, etransmit proposes a different folder (always the same), regardless of where the dwg was opened., so very often (automatically going when I make the etransmit) I do not find the zip in the folder of its dwg design.
then deepening, I went into the transmittal setup and found this path inserted between the options (tranmittal file folder), so I explain why autocad always proposes to me the default one. but I would like to return to the previous situation.
the value transmittal file folder cannot be empty, contain a relative path (type "\." oppose "), so someone gives me a tip on how to return to the old behavior (the same path of the open dwg)?
I can't even create a new "transmittal setup", because at the request of new creation autocad proposes me to start from an existing one, and the only one I have is the one with the incriminated path. so also doing a new one, the problem of the path remains to me.
that I remember, autocad took this "default path" from where the design resided, so doing the etransmit, always going ok,ok, saved the zip file in the same folder where the dwg resides.
for some time instead, etransmit proposes a different folder (always the same), regardless of where the dwg was opened., so very often (automatically going when I make the etransmit) I do not find the zip in the folder of its dwg design.
then deepening, I went into the transmittal setup and found this path inserted between the options (tranmittal file folder), so I explain why autocad always proposes to me the default one. but I would like to return to the previous situation.
the value transmittal file folder cannot be empty, contain a relative path (type "\." oppose "), so someone gives me a tip on how to return to the old behavior (the same path of the open dwg)?
I can't even create a new "transmittal setup", because at the request of new creation autocad proposes me to start from an existing one, and the only one I have is the one with the incriminated path. so also doing a new one, the problem of the path remains to me.
