bestialex
Guest
Hello, everyone!
I recently went to create parametric and compared to apro/and found some important differences.
often and willingly I used on pro/e the estimates, the automatic quotation system for the holes (x,y,z).
Unfortunately on creo I did not find this function and at the moment I am struggling because I should update all the drawings from pro/e to the new sw.
Can someone help me without using the "holes table" (very effective tool)?
do other similar systems exist or have they changed their name?
thanks to all
I recently went to create parametric and compared to apro/and found some important differences.
often and willingly I used on pro/e the estimates, the automatic quotation system for the holes (x,y,z).
Unfortunately on creo I did not find this function and at the moment I am struggling because I should update all the drawings from pro/e to the new sw.
Can someone help me without using the "holes table" (very effective tool)?
do other similar systems exist or have they changed their name?
thanks to all