export to dwg scale 1:1

[michele81]

I have a problem with export. I can't find the way to export the table in size 1:1 so that opening it with autocad is further quotable.
my problem is that pro-and export the design with the scale indicated in the cartilage.
This would also be good if it were not that the quotas indicate the real value but are applied to a scaled entity.
Therefore if I try to bring back the drawing in scale 1:1 the odds grow in proportion...and it comes a mess. for now I am forced to provide drawings in scale, stressing that no further quotas can be taken (unless not multiply them by hand by scale).
Can someone help me?thank you so much in advance!

 

[Fulvio Romano]

provide only .pdf!!!

apart from the jokes, if you stop the autocad odds change the numbers? If yes, it means that autocad recognizes them with dignity of quota, and therefore pro-e should be able to export directly to the right scale.

otherwise, if you go in a hurry and the design is not susceptible to further changes, explode the quotas and then scale everything. careful, that is a cow that can be admitted only in dramatic situations!

 

[michele81]

unfortunately no pdf.
I can't find where to tell him to export in 1:1.
if I set the sheet scale in 1:1 in pro_e the sheet is actually reduced in 1:1 and is very small compared to the pieces.. .
Any advice?

 

[Petruz]

I usually go to the proe .drw and change the scale in 1:1 after which I save copy in the 2d format I want.
at this point the file you open with the 2d program is 1:1 scale and has no problem incompatibility between quotation and the size of the piece.
the only problem is that by climbing the .drw in scale 1:1 the quotation goes where it wants therefore it touches you to re-set all the putting into the table.
I think you should give the supplier a pdf file of the quoted table and the .dwg file in scal 1:1 without quotas where it can detect the size they need.
bye:

 

[mamobono]

Hello try to put these settings in the config.dtl

attached file

Hi.

 

[michele81]

I have no config.dtl.. .
it is not much that we use pro_e and the formats in which design I was given by the customer... If I look for in the design options I can't find those settings.
how do I find them or create this config.dtl?

 

[michele81]

correct... I found those dxf_out settings... in the config.pro...now I try if it works...

 

[michele81]

Okay! !
Thank you very much!