extract data x cylindrical cam

[LuiVerde]

Hello everyone
I have this problem: I'm trying to figure out how to design a cylindrical cam with accelerator design, I create a cylinder with the throat I want and so far all right but once I created my cam which geometric data I can extract (for cnc).
maybe it's just a 3d representation and so I just have to export the 3d file?
or is there a way to export the path to the tool?
Hello and thank anyone who can help me

 

[meccanicamg]

hi, with the design accelerator you have the panel for the design of the cam with all laws of motion, forces in play and verification of the case. the result is a 3d model of the cam with a set of stitches interpolated by a spline. therefore you will have only the 3d model and the points to quote when you make the table. Also for the rays you can not use them so. or you have a cad/cam that can use the spline or you have the following variants: draw the rays approximately that replace the spline (worst method), make a series of very close points so that with g1 you move some tenth point to point (most simple and good quality method), build the cam according to the traditional method with known cerhium arches (best and complex method according to the cam).

This is how much I could verify. in all modelers the construction of the cam is entrusted to a spline.