extruded parts descriptions in welding

[ansyolitico]

Hi.
is it possible to give a description of the extruded parts in a part where a structure has been made through weldings (scratch and profiles)?

the problem arises from separate cutting where I do not have the compiled description fields
Should they be hand-made by 2D?

 

[Dum]

Yes, absolutely.
As for tubulars, you must have a custom property in which you put the type of tubular, the same property is then recalled in the table in a column.
for the various plates instead, ask under the heading "cutting list" to create the "setting rectangle".
automatic sw will rename all extrusions as "plate" with its maximum measurements.
Those fields there should automatically appear in the cutting range, without having to do anything else.

 

[ansyolitico]

on the tubulars there are
I am not on the extruded plate, it is only one part is not a set, I would not have built badly
where do I find "selecting rectangle"?

 

[Dum]

premiumcreates delimitation pane (I was wrong with the command name)after

 

[ansyolitico]

Thank you so much.
but I am afraid that the carpenter that makes the crude does not respect the supermetals
I'll explain.
a flat plate and reach to thickness 20, should start with thickness 25 at least, on the table I have the finished measures. Is that correct? because in the past they often came out discussions because they never looked at the design but the table and had happened that in the table there were refugees, so wrong piece

 

[Dum]

in the welding environment, sw sets already 2 configurations, "machine" and "welded".
just configure the different plate thickness between the two configurations and automatically updates the table.
clearly, the welding table will have to refer to the welded configuration and any flame cuts that you insert in the design will have to be of the welded configuration

in the model window click with the right on the portion you want to configure (in this case the thickness)in the table that opens you impose the two valuesand close.

At the end you will have such a condition

machine configuration
welded configuration

 

[Dum]

I'm sorry, I'm lying.
the welding table refers only and exclusively to the "saved" configuration, you can't make it point to the machine.

 

[ansyolitico]

Mom, thanks, I didn't know. I owe you a beer barrel