family of internal stained glass walls

[luar]

good afternoon, someone can help me by explaining the correct procedure to create a family of internal stained glass walls, single and double layer, with sliding doors and normal and with fittings and beams made up of a couple of different profiles, taking into account that I have the need to make the quantity relative to the individual profiles appear in the abacus and not to the full frame or traverse. I thank everyone who can give me suggestions.

 

[Tristan]

impossible to explain something like this in a post...

 

[luar]

and where can I find suggestions?
I have created a family as detail components, treating it as if it were a window, but I do not know whether it is correct to nest it within a family of the category windows.thanks

 

[Ale Santini]

Iuar, have you tried with the continuous facades?
to each single panel you can apply a single and double layer glass
always in reference you have panel, you can apply, instead of a fixture, a door at will (must be part of the family of continuous facade panel)
finally you can select the individual mounts and make sure they are composed of a particular profile.
to do this you create a family "meter profile" and add it to the project, then duplichi a family of climbers already present in your project and change profile by replacing it with the new one you loaded

 

[luar]

thanks for the suggestion; I'll try this way!