family table problem after some openings of the assembly

[giocamb]

hello to all
attached I uploaded an image of a problem on the family table..this error comes out to my colleague after a few times opening the assembly.
if the message answers you delete all the variables of the model, it seems to me a very strange error also because with the same software release itself to me it never happened.

I create 2 m100.

thanks and good work to all

 

[nino67]

It seems a very strange error also because with the same software release itself to me it never happened.

Hi, it seems strange to me too! Have you tried to "pass" your config.pro and sup, if you use it, to your colleague? I don't think a variable can generate "strange" behavior but if you don't experience this problem and if the release is the same............

If the problem disappears at this point you have to analyze the differences between the two configurations to see what triggers the event, at least I would do so.

greetings