cervetto
Guest
Hi.
How do I draw the thread in a screw? ? ! !
Thank you very much
How do I draw the thread in a screw? ? ! !
Thank you very much
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Tristan
Guest
in 2d o in 3d?
cervetto
Guest
3d con revit
Tristan
Guest
I see her very hard. a revit lacks a fundamental primitive to create a thread: the propeller!3d con revit
MB78
Guest
Assuming that what you're trying to draw, in building is a criminal practice... :wink: for the creation of the thread see:
http://bimtroublemaker.blogspot.it/search?q=spring
http://buildz.blogspot.it/2010/01/how-to-make-smooth-helix.htmlLet us know if you're running, good job.
bye
mb
http://bimtroublemaker.blogspot.it/search?q=spring
http://buildz.blogspot.it/2010/01/how-to-make-smooth-helix.htmlLet us know if you're running, good job.
bye
mb
marcof
Guest
Drawing a thread in 3d is a criminal practice, besides useless, even in mechanics despite all the mcad3d can create a thread without problems. . .Assuming that what you're trying to draw, building is a criminal practice. . :wink: