first experience: inventor 13 vs solid edge st4

[aleluca]

Good morning, I want first to say that I am experienceless about 3d design software.
for work reasons (in a few months my job will vary from the business sector to the design industry) I need to learn how to use or inventor or solid edge. Since my company uses both of them, I would kindly like to know which of the two software is easier to learn and if I learned how to use one I will know how to design with the other.
thanks in advance for the help! ! !

 

[cacciatorino]

Since my company uses both of them, I would kindly like to know which of the two software is easier to learn and if I learned how to use one I will know how to design with the other.

I don't know inventos, but if it's like the other 3d windows-style I would say that it's quite indifferent to learning one or the other: you can transfer acqusitie knowledge with one fairly easily on the other. .

 

[aleluca]

Thank you very much for the advice! I think then I will devote myself to solid edge to learn and then I will hang on both! thanks again!