flat model, help!

[emagerry]

Good morning to all,
I have already read some discussions but I have found nothing to do with my case.

in the image I attached you see a cylinder.

What I wanted to do was to disengage a trapetidal sheet in a way that would create a cylinder.

Since I don't know how a sheet metal with inventor rolls, I made a tube to which I cut a helid.

Now my problem is if you can create flat model.

Can anyone help me?
Thank you very much.

 

[PierArg]

try to do this command:

other discussions -> discussions off topics -> presentation



Then we'll talk about it for the rest, okay?

you were lucky that you didn't "beccato" before me gerod...otherwise they were poops

 

[emagerry]

Sorry, it's before I participate in a forum.

I'll take care of it.

 

[emagerry]

That's it!

 

[Alby189]

What version of inventor do you use?

 

[emagerry]

I use 2008.
I built the cylinder as part and then converted it into sheet metal.
the problem is that I managed to make the flat model by chance then I didn't save and now I can't.

 

[Alby189]

an essay here in the forum gave me a scary tip on developments: If you can't remake the development, try to remove it from the tree to the left and do it again! !