flat repetition

[New Rider]

Hello everyone,

as never sometimes I can insert the flattened/developed view into the table.
I press that in the 3d model the flattening function works.View attachment 001.51.514.SLDPRT.7z.

 

[volaff]

Hello everyone,

as never sometimes I can insert the flattened/developed view into the table.
I press that in the 3d model the flattening function works.View attachment 46759.

try to delete the flattened function from the side by going to "configuration manager" and repeat the procedure.

 

[New Rider]

try to delete the flattened function from the side by going to "configuration manager" and repeat the procedure.

nothing to do

 

[volaff]

nothing to do

in the part feature tree is expanded complement?

 

[MassiVonWeizen]

flat repetition at the end of the tree cannot be erased, it is created automatically at the creation of a sheet. you can delete the development configuration. the flat repetition should be activated with the special command only for verification of feasibility.
new rider, when you enter the view, does the voice appear flattened?
volaff, what does the expansion of the tree have to do with it?

 

[New Rider]

flat repetition at the end of the tree cannot be erased, it is created automatically at the creation of a sheet. you can delete the development configuration. the flat repetition should be activated with the special command only for verification of feasibility.
new rider, when you enter the view, does the voice appear flattened?
volaff, what does the expansion of the tree have to do with it?

when I make the table one of the views of the palette is indicated as flat repetition and brings a verdant check on it but is not developed.
Very strange... .

 

[MassiVonWeizen]

probably in the development configuration the flattened repetition is suspended.
if you start from an existing sheet or change to a file with the above configuration you must be careful about what configuration works

 

[New Rider]

probably in the development configuration the flattened repetition is suspended.
if you start from an existing sheet or change to a file with the above configuration you must be careful about what configuration works

That's the problem. the repetition was not activated in the configuration .
solved. .


thanks and good work.. .
Hi.

 

[volaff]

in the part feature tree is expanded complement?

I meant that the flat repetition could be suspended if the tree wasn't all expanded. I expressed bad.

 

[MassiVonWeizen]

You felt bad now. if the flat repetition is suspended it is at the top level and you also see it with compressed tree

 

[Sludge]

guys I have a problem I'm going out crazy ... it doesn't make me bend the plate tells me error repeating flat the bending game could be too small use the 2018 version ... even if I make a new piece I always make the same mistake

 

[il puma]

hi sludge,

a question: what piece is it?

verify its feasibility by bending only,
Could there be an intersection of lembi in flat repetition?

 

[Sludge]

I don't know what happened. Anyway in the end I managed to solve everything by doing it all over again

I am trying to make a bumper with the use of sheet metal