jasmtn
Guest
Hello everyone
I ask for help in flattening this geometry.
Thank you.
I ask for help in flattening this geometry.
Thank you.
- Home
- Forums
- mechanical engineering
- creo parametric (ex pro/e)
- creo parametric - modeling of parts and sheet
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
fenice consulenze
Guest
with which relaise did you realize it?
jasmtn
Guest
with which relaise did you realize it?
con wildfire 4.0
fenice consulenze
Guest
In general, if you use the sheet-metal module, you have the option, through the appropriate command, to flatten the model. that I know is the only way to do it, clearly if someone has a better idea to help jasmtn... .
AMinati
Guest
This geometry is not directly developable, you must first break it into developable elements (the two cylinders and the cone), then make tears along a generator and then you can proceed to development (total or piece).
I suggest, however, to start making the component as a combination of the three small cylinder pieces, cone trunk and large cylinder. in this way you will be able to do everything easier, even because in reality the particular I think you will have to do it just like that.
aminati
I suggest, however, to start making the component as a combination of the three small cylinder pieces, cone trunk and large cylinder. in this way you will be able to do everything easier, even because in reality the particular I think you will have to do it just like that.
aminati