flexible spring spring

[ingmec]

Hi colleagues, I tried to find in the 3 different discussions but I did not find exhaustive explanations. What I want to know is how to make a flexible component in a set. I have created a banal with two plates at a distance x between them. now I have created the spring and I would like that when I put it in the axieme, this "follow" the distance between the two plates. you could describe the modus operandi step by step to make in this case the flexible spring. I use pro-and wf2.

 

[DANI-3D]

hi, read this discussion, should be enough
http://www.cad3d.it/forum1/showthread.php?t=25781

 

[ingmec]

Thank you, dani, I had already read the post. What I can do is this: I create a spring and already in the setup part the flexible rendo for value. so in my set, when I go to insert the spring, knowing the distance between the plans I insert the new value and the game is done. my question was this: I would like to make the spring flexible according to the distance between the floors: I mean, I want the spring to fit according to the distance between the floors I go to immetere. I hope I've been able to break out in an exhaustive way

 

[DANI-3D]

the process is right, only make it flexible not by value but by distance, select the surfaces or contact plans of the spring and the game is done, the spring will adapt accordingly.

 

[dema]

http://www.youtube.com/watch?v=10lxkqvaty4I hope to have been clear, the important thing if in the axieme we want that moving the components the spring automatically adjusts to the method by value that allows to change the length of the gas spring from a static value to another the method by distance and in the case of the gas spring in question touch the axes of the pins on which the spring will then be mounted, so that to vary the distance of the two pro/and recalculating pins.

 

[ingmec]

perfect colleagues... thank you very much. Everything works perfectly. Since I wanted to ask you something else... I don't know whether to open another discussion or not... I'd like information to handle the components using the skeleton. I don't know anything about the skel environment. Can you recommend me some good guides?