folded part with scapulation. command "folding".

[matacad]

Hello, guys.

no started a new job where you use I create 4, not use it for a few years.

I need to create a piece of sheet metal like the one I made with v5 cat, where I executed the bending command, and doing in the sketch the fold line divided into two.
with I create this is not possible. How can I get the same result?

Thank you in advance.

 

[DANI-3D]

Hi.

If I didn't get it wrong, would you get this?

 

[320i S]

tried with straightness of the only flap?, or cut the folded part and the remaining flap extend it as much as you want.

 

[matacad]

hi, only that flap does not flatten, the program sees it as a single fold, so it flattens everything. I solved by making a pocket without that central tab, then that tab I added it with the "plan" command.

 

[matacad]

Hi.

If I didn't get it wrong, would you get this?

Yes, exactly, but in different ways from yours.

 

[freexf]

with the following order:
flat wall
Folding sheet
flattening
Cut
folds choosing "keep flat" in the blindfold