from creo1.0 to wildfire5

[casino]

Good afternoon
an American client sent me files generated with creo1.0, I have a wildfire5.0 full.
the client gave me the file "readnewmodel.dll" telling me that with this file I could see the files I create even if I would not have seen the construction trees.
the problem is that when I open the pc tells me that this dll generates an image not valid in windows.
any of you have creo1.0 in windows and can give me the dll, it is located in the gcri folder inside the folder where it is installed proe.
Thank you.

 

[Parametric_Ozzy]

Good afternoon
an American client sent me files generated with creo1.0, I have a wildfire5.0 full.
the client gave me the file "readnewmodel.dll" telling me that with this file I could see the files I create even if I would not have seen the construction trees.
the problem is that when I open the pc tells me that this dll generates an image not valid in windows.
any of you have creo1.0 in windows and can give me the dll, it is located in the gcri folder inside the folder where it is installed proe.
Thank you.

cgri for wildfire 5.0 compared to creo still has not been released.
ask your American customer to save the files in neutral format.
greetings

 

[zimmy]

It works for me.
from creo1.0 to creoelementspro 5-m100
I have respected the following:
How to do:
copy readnewermodels.dll file from
creo parametric 1.0 loadpoint\common files\datecode\i486_nt or x86e_win64\gcri folder
paste readnewermodels.dll into
pro/engineer wildfire 4.0 or 5.0 loadpoint>>\ i486_nt or x86e_win64\obj folder.

refer the following documents for detailed information about*gcrihttps://www.ptc.com/appserver/cs/vie...n.jsp?n=132326http://www.ptc.com/wcms/files/62618/...on_to_gcri.pdfthe readnewermodels.ddl file is 22mb . I do not attach it.
I attach two images for clarity.

 

[casino]

Thanks zimmy, you can send it to m.bonetti@selcom
group.com, the file they gave me is 23mb but it seems not good, I fear it is for mac since the customer is American.
Thank you.