from the text command in sketch, is it possible to define a sentence on multiple lines?

[MORENO100]

Hello everyone,
from the "text field" of the "text" command in sketch mode, can you define a phrase that will be displayed on multiple lines?
Is there a particular formatting to use?
thanks and good work to all.

p.s. use wf5

 

[gio14]

enter the text command write the first line of the font you want, then confirm the position of the second row and so on (then obviously outside the text command you can move the position to increase the font size etc.)
There is no special formatting, only thing is that if you want to use them for an extrusion or offset you need to create another sketch and use the "create entity from the edge" command to recopy them

 

[dema]

If I understand you'd like the text to run automatically, right?
Unfortunately this function or does not exist or I don't know her...

 

[gio14]

If I understand you'd like the text to run automatically, right?
Unfortunately this function or does not exist or I don't know her...

look at this type of command I use it with a certain frequency to create writings in certain molds and I find it correct that you can write it on one line at a time (without, automatically) otherwise you would limit the command because you would be unable to insert it on a curve (essential thing)

 

[sma73]

... I don't think you can do it. .