full listing model

[Bitto87]

thanks massi....si it is true, I have asked a few questions, a little for a little time available a little because, to be honest, I came to the minimum union, i.e. to quote the piece and just... is true the quota 17.65 is the least one, I could have done more, to the decimals I had not thought, I know that they involve a precision of too high processing, ergo high costs, I will have to send them nothing, before to do it 1.6 global all right? You tell me, I'll break you once again, I hope you'll help me one last time... Thank you.

 

[MassiVonWeizen]

I was aiming at the minimum union, that is to quote the piece and just

bhé complimenti... Good way of thinking.
to me if one doesn't put on his own and he gets banged at least a bit passes the desire to explain things.

 

[Bitto87]

I'm not that I'm not banging, but I'm a period no...I'm not explaining much but between work that doesn't leave me time (and I don't like it because there is no ca.. or with how much I studied) my father who is not well and fight with a bad bad bad, and various other problems I have engaged me little... I don't know how to compartment, if my head isn't short or nothing, and I'm sorry because I step for a goat or worse, and I'm not

 

[MassiVonWeizen]

After so much help that you were given, you could at least let us know how the trial took place and how the situation is evolving.

 

[Bitto87]

Sorry you're right,it's that I've been using little internet lately since I have few giga on my mobile phone and I don't have the pc with me.the test went great, they made me draw 2 complex beautiful pieces, then they did me an interview.passed about,10 days they called me back and made the recruitment proposal, which I accepted! I've been moving a little more than a month north and things go well.. thanks!

 

[matteoo]

If you're really an engineer, I'd say it's necessary to have manuals and books for the profession, you should have them for the study to become an engineer.

Of course, to go well, for example in most workshops, you don't need the geometric tolerances you put at all. for example no one will make you 0.8 where there is the bearing seat because sending it to rectification costs 150€ plus that piece and they would miss the center holes, so that everyone would make it back with widia insert with roughness 1.6 that is practicing the maximum that you can do with an old standard lathe.
the rays you have marked apart the big one will be made with r=0.4 or r=0.8 because they are the rays of commercial plaques and will not be interpolated to make such a small radius even with cnc.

as you see who are different views: theorist, the practical, the cellar etc. etc.

depends where you clutter, but it is good to know all three ways because depending on the situations it can serve in a targeted way one of these modes.

even the fact of quotating each step could be opinabile and in parentheses the total. probably it's the first lower share that doesn't matter. instead should have it from the floor pad flange and perhaps tolerated.

as you see, we need to create the critical spirit of analysis and evaluation.

great comment