gasolines

[round]

Good morning.
by good pivello stó trying to understand how the solidworks splines work and in particular the equitable curvature and the influence of this parameter on the later created surfaces and when it is the case of using it or where it is better to remain only tangents .
If someone has a few tips I thank you in advance.
d

 

[nino66]

the fair healing means that the passage of the value of the radius will be proportional, in other words if you connect with a spline 2 lines (see image) the curvature of the spline with the equa curvature will have a proportional passage from the infinite radius of the line to the radius of the spline in the central point unlike that only in tangence that will pass immediately after the line to the bending radius you want.
all this is used in cases where on it wants to show less the passage and, of course, more on the surfaces and it is used more (at least according to my experience) when models aesthetic pieces where the quality of the surfaces is important and perhaps a simple fitting can be at the sight "spigoloso".
I hope I was useful and a little clear....

 

[round]

Thank you very much.
d