themole
Guest
good morning, it is possible in sheet metal to insert a jealousy (and so far with ifeature) but then to developed model does not create me the wound to print.where is wrong?
Thank you.
Thank you.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Catafratto
Guest
errors in the software, in the sense that inventor does not:tongue:.
It is not possible to develop deformations of that type, or, for example, the typical stiffening damping. . .
It is not possible to develop deformations of that type, or, for example, the typical stiffening damping. . .
themole
Guest
beautiful there, but do you think it is better inventor 2015 or solid edge st6?
stefanobruno
Guest
inventor 2015 is not yet available.
Catafratto
Guest
Question of the year, punctuation forum! I suppose that each program has pros and cons and that to have net differences it is necessary to pass to well different price bundles. I used only inventor and so I'm out of this kind of discussion, although I would like to find (until I failed) a comparative analysis a little detail of pros and against the most popular 3d modelers.beautiful there, but do you think it is better inventor 2015 or solid edge st6?
Inventor3D
Guest
Hi.good morning, it is possible in sheet metal to insert a jealousy (and so far with ifeature) but then to developed model does not create me the wound to print.where is wrong?
Thank you.
ahimè inventor does not manage these processes directly.
to remedy you should ask your dealer a valid plug-in, like this:
http://www.sheetmetalinventor.com/en/
ciao