give a specific deduction to a section of a part.

[leggera]

Hello.

I have to make a design with 5 mm red leds from other whites.
having a b/n printer when I print I don't recognize them.
Is there a possibility to associate a type of section with a part ?
In this way I would be able to recognize them.

it would be better if I could recognize them without making a section only in front view, but I think I ask too much.. .


Thank you.

 

[TECNOMODEL]

select the led lines that interest you and change the layer by choosing the format you like. drawn, drawn-point, point etc.
or, if it is a section, select the calibration and change it to your liking from the property window.