GiGa Guest May 6, 2013 #1 in a drawing together I must show "the contour" (obviously already set as "reference") of the plant. the problem is that I can't find the way to show the complete reference not only the chosen part so "arbitrary" by inventor.. .
in a drawing together I must show "the contour" (obviously already set as "reference") of the plant. the problem is that I can't find the way to show the complete reference not only the chosen part so "arbitrary" by inventor.. .
stefanobruno Guest May 6, 2013 #2 clik-clik on the incriminated view --> tab "model status " --> reference data box --> change the margin value, increasing q.b. Bye.
clik-clik on the incriminated view --> tab "model status " --> reference data box --> change the margin value, increasing q.b. Bye.
GiGa Guest May 6, 2013 #3 What chicken I am! :biggrin: the only parameter I didn't try... Thank you very much!
