grooved profile modeling

[giulio1993]

good evening to all, I have a problem I wanted to know if there is a way to quickly model a profile channeled on a tree so that in putting into the table already all the correct lines from regulations.
Thank you for your attention

 

[meccanicamg]

good evening to all, I have a problem I wanted to know if there is a way to quickly model a profile channeled on a tree so that in putting into the table already all the correct lines from regulations.
Thank you for your attention

the correct lines from regulations are simply two lines as if it were a thread.

Thus all cads can be drawn two solid circulars not united or two solids of unified revolution.
certainly drawing the whole profile can be complicated and not always useful or indispensable.

 

[MassiVonWeizen]

Thus all cads can be drawn two solid circulars not united or two solids of unified revolution.

I'm sorry, I didn't understand your sentence. Can you explain it to me? Thank you.

 

[meccanicamg]

inside tree and outside tree corresponding to the toothing. the first is the hazelnut. two solids not united.

 

[MassiVonWeizen]

Okay, now I get it. you intend to make two solids as from image, red the teething and green the tree, so as to simulate the line of the teeth according to regulations.

 

[meccanicamg]

Okay, now I get it. you intend to make two solids as from image, red the teething and green the tree, so as to simulate the line of the teeth according to regulations.

That's right.
with solidworks you can also use the surface.... but always that is the strategy.

 

[MassiVonWeizen]

@ giulo1993 have you forgotten the discussion or have we written for nothing?
in a forum, as in real life, it is good and right to let you know whether the received information was useful or not.