halfway geometry

[volaff]

Good morning, a question to fly.
but in sw there is a command (stile offset) that, for example, by selecting two circumferences (just to say one ) gives you the circumference placed in halfway between the two offset styles?

Thank you all.

 

[FIGOR71]

Hi. .
from your post you do not understand very well where you care to do this, whether from a table or on a side.. .
However if you make a table of a part 3d you just have to use the command "middle line"
If you have to do it in a sketch, I can't help you. . This is not autocad...

 

[volaff]

Bye.
I was referring to the sketch of a particular part.


thanks for the answer

 

[marcof]

Good morning, a question to fly.
but in sw there is a command (stile offset) that, for example, by selecting two circumferences (just to say one ) gives you the circumference placed in halfway between the two offset styles?

Thank you all.

No.
Perhaps it is feasible with the programming of macros.

 

[volaff]

No.
Perhaps it is feasible with the programming of macros.

Thank you for your clarification.

 

[meccanicamg]

not directly. However, you can do a random offset with a known value and then create two equal long construction segments related to the offset share.
No macros or strange things.

 

[marcof]

not directly. However, you can do a random offset with a known value and then create two equal long construction segments related to the offset share.
No macros or strange things.

Well, if someone feels the need for a command that from the selection of two geometric entities automatically draws another one with certain characteristics it is not that you can tell them made the construction to handle and no macro ceh are strange things.
It's just the command you're looking for.
who wanted the rectangle for three points needed it, he did not need to feel advised to draw a rectangle any then drag the three reference points and bind them to the desired entities.:tongue:

 

[MassiVonWeizen]

not directly. However, you can do a random offset with a known value and then create two equal long construction segments related to the offset share.
No macros or strange things.

When constructing geometry, you can alternatively draw an offset line between the entities involved and bind the halfway entity to the middle point of the construction line.

just to propose an alternative.
are about the same steps, difference of a few seconds as timing.

 

[meccanicamg]

When constructing geometry, you can alternatively draw an offset line between the entities involved and bind the halfway entity to the middle point of the construction line.

just to propose an alternative.
are about the same steps, difference of a few seconds as timing.

and not for this it serves a macro.
I would say that the first goal of the request was if there was a more or less automatic way to get medium offset and so far we have two valid methods.