have two types of rays (one for stamping and one for bending) of a sheet (solidworks 2019)

[GHOSTMAN]

Good morning to all,

until today on a certain sheet (Greek sheet) has always been made with bending, so the process is long. Therefore it was thought to create a mold and mold the sheet, but there is always a part of the same sheet that by force are executed folds to create the desired shape.
my question is, on solidworks (2019) it is possible to have two different bending rays on the same sheet, one for sheet metal molding and one for sheet bending (by preventing the fact that it will change factor k and that I will have to go attempts to have the length that has always been on this sheet) ?

 

[MassiVonWeizen]

Sure.
enter the fold function and overwrite the value.
if you expand the function you find the individual bending subfunctions to which you can assign a specific retreat and radius

 

[GHOSTMAN]

Thank you very much @massivonweizen