heavy file after geompiatta command application

[bodofr@alice.it]

Good morning to all!! !

I composed a cottage in 3d with autocad: total file 5 mb. the pc handles it well with render and with the materials.
I used geompiatta (cutting the check on shows hidden lines) to make four orthogonal projections from as many sections.
the file then contains now the cottage + 4 sections (on one floor) and nothing else : total 33 mb. It is true that the orthogonal projections often have more overlapping lines, but I cannot believe that some lines can increase the design of 28 mb!!!
result: pc almost implanted and however very slow.



I would have two questions:
1) Does anyone know where they come from? ?
2) how to remove the overlapping lines. Maybe not one at a time? ? ?

I thank from now on the genes that always have an answer in this forum.. .

 

[Tristan]

is very full as an increase. Strange. Try to explode the views and make a nice purge. if I remember badly the command to eliminate the overlapping lines is overkill

 

[bodofr@alice.it]

autocad use 2010 and I couldn't find any command (not even in the manual) that talked about double lines elimination. overkill does not recognize it and not even the countless variations in Italian that I found around. purge created good effects at the end I found the .lsp file (here: http://wiki.profsionearchitect.it/w/eliminare_entità_identiche_sovrapposte ) that worked very well! ! !

Thanks again... hello! ! !

 

[Tristan]

probably you have not installed express tools