help! a solid turned into the surface

[3138]

Hello, everyone!
I have a huge problem that I have to solve, and my degree goes away!
I realized a project in inventor and I do not know how one of the parts of the assembly by solid part became surface and in this way when I create the .idw file for the technical tables that part turns out invisible.
Does anyone know what happened? or how to reconvert it in solid? ?

Thank you so much! !
f.

 

[Catafratto]

Did you make a simplified contour of the axieme? or manually remove any face of the surface? or any components downloaded from the internet? However on the table you can right-click on the surface and tick all surfaces to bypass the problem without solving it.

when your degree is less in danger presented in the specific section, thank you:wink:

Good luck!

 

[3138]

No no until yesterday the axieme was all set, and I had already made tables... then I assigned a material to the part in question and saved a different file in .stp and today I had this nice surprise!

You make the wolf!

 

[stefanobruno]

attach the file that causes you the problem.

 

[3138]

attach the file that causes you the problem.

Here we go! a surface, but it was created as solidView attachment bidup_remake.ziptks!

 

[3138]

Guys, I got it.
Thank you very much.

 

[stefanobruno]

eliminate face1 & eliminate face2 are the guilty.
If you suppress those two jobs, everything is solid.

Bye.

 

[3138]

That's exactly what I just did! stupid me! 4
Thank you!