help modeling inner rib

[lollone]

Bye, guys.
I am designing a model using the surfaces (with what little I know).
I would like to get some internal ribs and to do so I thought I would draw them and then eliminate the protruding parts from the carcass.
Is there a command running this trim?

I attach the file.

Thank you.

 

[Counterblow Hammer]

Bye, guys.
I am designing a model using the surfaces (with what little I know).
I would like to get some internal ribs and to do so I thought I would draw them and then eliminate the protruding parts from the carcass.
Is there a command running this trim?

I attach the file.

Thank you.

I hope I got it right. . .

 

[lollone]

Unfortunately I can't open the file! I have wf3 and wf4.
Can you explain it to me?

 

[Counterblow Hammer]

Unfortunately I can't open the file! I have wf3 and wf4.
Can you explain it to me?

I was writing to you: forgive me! I did it with creo! .

cmq to say fast:
- selection of all carcass surfaces
- crtl+c (copy)
- ctrl+v (glue): at this point you will find a single closed surface which is not the external sup. of your carcass
- Cut off the rib using the sup. to refill the sup. just copied
- et voilà

p.s.: I can't change the file because I leave wf5, I'm sorry. . .

 

[lollone]

when you say select all surfaces of the carcass what do you mean? How do I select them?
Sorry but with the surfaces I'm just ignorant! ! !

 

[Counterblow Hammer]

when you say select all surfaces of the carcass what do you mean? How do I select them?
Sorry but with the surfaces I'm just ignorant! ! !

selections with the mouse holding crtl.

on creo (I don't know if wf works) just select one (eye that has to become completely red! this makes you understand if you have selected a surface or not...), hold crtl+maiusc or select another, release the keyboard keys and automaticmnete selects all the external surfaces of the component. . .

 

[Mauri:66]

You mean that?
Hi.

 

[lollone]

Mauri66,
No... I'd like to remove the surface outside the carcass and keep the inside.

 

[lollone]

I just get red in the perimeter!
I can not select the complete surface...'tacci her!!!cmq after eaten I try again with more calm!!!
Thank you so much!! !

 

[maxopus]

You know I don't know what you want to do?
I also don't understand a few things:
Why did you model with surfaces and not solids?
Why did you use extrusions and not blend for the main solid?

 

[Mauri:66]

in fact maxopus is not wrong...however you see if that's what you meant.
Hi.

 

[lollone]

Yes! !but in fact I made a caxxata to do it with the surfaces! I thought it would facilitate me of the operations but it is not so!!! !
Thank you! ! ! !