how to access commands?

[TonyEsp]

Hi, guys, I hope I don't ask a stupid question, but looking on the net, I just don't find an answer. I come from sw and I was playing with siemens nx, but I can't find the commands
i.e. if you want to run the bounded plane command where I find it? I managed to access it only by looking it in the search bar but it is uncomfortable. Sorry the awkward question

 

[wall87]

where there are the commands in the top bar click with the right mouse and the window that opens you go to customize.
At this point you will open a new window where if you already know the command you can search for it and then you can move it to the command bar so you will always find it.

 

[ceschi1959]

ciao @tonyesp ,
from what I see in the image, you have the essentials role.
you have to put the advanced role, then in menu>insert you find all the logically divided nx modeling commands.
Look at the footage.
Hello there.

 

[TonyEsp]

Thank you!!!!

 

[TonyEsp]

where there are the commands in the top bar click with the right mouse and the window that opens you go to customize.
At this point you will open a new window where if you already know the command you can search for it and then you can move it to the command bar so you will always find it.

thanksssss

 

[TonyEsp]

Hi, guys, I'm also asking this: I don't find the group for quotas. I can't find him... what do I do?

 

[ceschi1959]

What is the quota group? What version are you using? did you play advanced? Have you looked in menu>insert>synchronous>modeling?

 

[TonyEsp]

thank you for replying, I got confused looking at a tutorial for a version earlier than my